MPas Hydraulic-set Packer
The MPas™ formation packer is a primary cementing and zone isolation packer utilizing a non-inflatable packing element run as an integral part of the casing or liner string to provide a permanent seal between the casing and wellbore.
Rotationally locking pins on either side of the element prevent element damage while running in hole. The MPas contains an elastomeric element with composite structure that is set mechanically by applying a hydraulic pressure differential from the packer inside diameter (ID) to outside diameter (OD). When the differential pressure is high enough, the lower piston shears and moves down releasing piston has hydraulic differential pressure and hydrostatic pressure acting against an atmospheric chamber. The force acting on the setting piston mechanically sets the element. The setting force is locked into the element by a body lock ring so that the element Remains set after the hydraulic force is released. The hydrostatic setting force continues to act on the element so that it will continue to conform to the wellbore even if its geometry changes over the life of the packer. This design allows for additional hydraulic setting force to be applied to the packer at any time during its life.